HP/Agilent 10462A 3-State TTL/CMOS Data Pod uses the 10474A Lead Set
Each Agilent 1670G Series pattern generator (Option 004) needs one clock pod and up to four data pods. Each data pod provides eight output channels.
Order 1 to 4 sets where a set is (1) of these 8-Channel data pods + (1) 10474A lead set.
FEATURES:
- Output typenote 2: 74ACT11244 with 100 O series; 10H125 on a non 3-state channel 7
- 3-State enable: negative true, 100 kO to GND, enabled on no connect
- Maximum clock: 100 MHz
- Skewnote 1: typical <4 ns; worst case = 12 ns
- Recommended lead set: Agilent 10474A
- Note 1: Typical skew measurements made at pod connector with approximately 10 pF/50 kO load to GND; worst case skew numbers are a calculation of worst case conditions through circuits.
- Note 2: Channel 7 on the 3-state pods has been brought out in parallel as a non 3-state signal. By looping this output back into the 3-state enable line, the channel can be used as a 3-stated enable.
